KTM 250 EXC-F 2014 Setup Instructions page 6

2 SETUP
(EXC-F SIX DAYS)
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
Screw, bottom triple clamp
–
Remove screws
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
Guideline
Screw, handlebar holder
101488-10
–
Position the handlebar.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp
C00108-10
(EXC‑F EU, EXC‑F AUS)
–
Insert the indicator lamp with the black and black cable colors into
socket
–
Insert the indicator lamp with the black and violet cable colors into
socket
–
Insert the indicator lamp with the orange and brown cable colors into
socket
–
Insert indicator lamp LED with the black and black cable colors into
socket
C00521-01
Info
The rebound damping is located in the right fork leg REB (red
adjusting screw). The compression damping is located in the left
fork leg COMP (white adjusting screw).
Grooves are milled into the side of the top end of the fork legs. The
topmost milled groove must be flush with the top edge of the upper
triple clamp.
Position the bleeder screws toward the front.
. Take off the handlebar clamps.
1
. Take off the handlebar supports.
2
.
2
M10
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
.
3
.
4
.
5
.
6
M8 17 Nm
(12.5 lbf ft)
M8 15 Nm
(11.1 lbf ft)
40 Nm Loctite ®
(29.5 lbf ft)
M8 20 Nm
(14.8 lbf ft)
4
243™