Casio XJ-UT351W User Manual page 59

Command
Name
POS Setup Type*
APO Auto Power Off
STS Reads the projector
error status.
MIC Microphone Input Level
IDS Projector ID
*1 This setting is applied to the input source signal that is currently being projected by the projector.
*2 Setting 0 is the "Normal" setting when the input source is RGB or HDMI(PC), while setting 2 is the
"Normal" setting when the input source is component, HDMI(DTV), Video, or S-Video.
*3 Light Control Off Mode settings.
*4 The setting range on the projector setup menu is –60 to 60.
*5 Each KEY command setting corresponds to a remote controller key. The projector operation that is
performed in response to a KEY command is identical to the corresponding remote controller key
operation. When sending KEY commands to the projector from an external device, make sure they
are sent in the same sequence that the corresponding key operations are performed on the remote
controller.
*6 Specifies how the projector is set up relative to screen for projection. Corresponds to the projector
setup menu "Projection Mode" and "Ceiling Mount" commands.
Function
6
0: Projection with top of projector upwards, screen in front
1: Projection with top of projector downwards, screen in back
2: Projection with top of projector upwards, screen in back
3: Projection with top of projector downwards, screen in front
0: Off, 1: 5 minutes, 2: 10 minutes, 3: 15 minutes, 4: 20 minutes
5: 30 minutes
0: Normal, 1: Fan error, 2: Temperature error, 7: Light error
16: Other error
0 to 3
0: All, 1: ID1, 2: ID2, 3: ID3, 4: ID4
Settings
59