Projecting The Screen Image Of A Graphing Calculator; To Project The Screen Image Of A Graphing Calculator - Casio XJ-UT351W User Manual

Projecting the Screen Image of a Graphing Calculator

You can connect a CASIO graphing calculator to the projector using a USB cable and project the
calculator's screen image with the projector. USB connection of the following CASIO graphing
calculators is supported.
 fx-9860G Series, GRAPH 25/35/75 Series
 fx-CG10/20/50 Series, GRAPH 90+E
 ClassPad 330 PLUS
 ClassPad II Series, fx-CG 500

To project the screen image of a graphing calculator

1.
With the projector turned on, connect its USB-A port to the USB port of the
calculator.
 To connect, use a USB cable with a Type A connector on one end (projector) and a Type B
mini connector on the other end (calculator).
2.
On the projector, press the [INPUT] key. This will display the "Input" dialog box.
3.
Use the [] and [] keys to select "CASIO USB Tool" and then press the
[ENTER] key.
4.
On the graphing calculator, perform the operation required for projection.
 For details about this operation, refer to the use documentation that comes with your
calculator.
Important!
 If the calculator does not operate properly after you connect it to the projector, try
disconnecting the USB cable from the calculator and then reconnecting it. If this does not
correct the problem, disconnect the USB cable from both the projector and the calculator.
Turn the projector off and then back on again, and then re-connect the calculator.
45