Casio XJ-UT351W User Manual page 33

Use this menu item:
Image Adjustment 2 3
Vertical Position (RCV)
Image Adjustment 2 3
Horizontal Position (RCV)
Image Adjustment 2 3
Frequency (R)
Image Adjustment 2 3
Phase (R)
Image Adjustment 2 3
Overscan (CVD)
Image Adjustment 2 3
Restore Menu Defaults
(RCVD)
Volume Adjustment 3
Volume
Volume Adjustment 3
Restore Menu Defaults
Screen Settings 3 Vertical
Keystone Correction
Screen Settings 3
Horizontal Keystone
Correction
Screen Settings 3
Correction Priority
Screen Settings 3
Aspect Ratio (RCVHD)
To do this:
Adjust the vertical and horizontal positions of the input source image in relation to
the target screen.
When vertical bands appear in the projected image while RGB is selected as the
input source, it means that the frequency setting is not correct. When this happens,
use this setting to adjust the frequency manually. If, for some reason, your manual
frequency settings cause the image input from the computer to disappear from the
projection, you can press the [AUTO] key to perform an auto adjust operation, which
should cause the image to appear.
Adjust the phase of the RGB input signal when the image flickers because the
projector phase and RGB input signal phase do not match.
Adjust the overscan amount for an input video signal within the range of 0% to 5%*.
The size of the border area displayed on the projection screen depends on the
setting value. A smaller value results in a wider border area as shown below.
Return all of the items in the "Image Adjustment 2" main menu to their initial defaults
for the currently projecting image source.
See "Adjust the volume level (VOLUME)" (page 25) for more information.
Return the Volume setting to its initial default for the currently projecting image
source.
Correct vertical keystoning of the projected image.
Correct horizontal keystoning of the projected image.
Enable or disable keystone corrected projection image distortion reduction.
Shape: Reduces projected image distortion when keystone correction is performed.
The resulting projection area will be slightly smaller than normal.
Size*: With this setting, the normal projection area size is maintained for a keystone
corrected image, but there may be some projected image distortion.
Select an aspect ratio setting for the projected image.
See "Change the aspect ratio of the projected image (ASPECT)" (page 25) for more
information.
Display range at 5%
Display range at 0%
33