Advertisement
8. Porous weld
9. Electrode sticking in gas cup (nozzle)
10. Irregular weld bead
11. Weld bead too narrow and raised
12. Weld bead too wide
13. Poor penetration
14. Excessive penetration
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative
versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
No gas
Gas cup clogged
Draft blowing away shielding gas
Rusty or dirty joints
Torch too far from or at wrong angle to work
Gas leak
Faulty Electrovalve
Worn or defective gas cup (nozzle)
Electrode deformed
Wire speed too slow
Torch incorrectly held
Wire weaving in weld pool
Weld current too low
Weld speed too high
Weld current too high
Weld speed too low
Arc too long
Weld current too low
Arc too long
Weld current too high
Weld speed too slow
incorrect distance of torch to workpiece
01284 703534
Original Language Version
Open gas cylinder, regulate gas flow
Clean or replace cup. (nozzle) (Section 3.9.4 to 3.9.7)
Screen off welding site or increase gas flow
Clean and/or grind workpiece. (Section 4.1.1)
The distance from gas cup to workpiece should be 8 to 10mm
Check hoses, connections and torch assembly. (Section 3.5). Press the gas cup in
correction position
Clean out or replace
Replace gas cup (nozzle). (Section 3.9.4 to 3.9.7)
Check roller tension. (Section 3.10)
See recommendations for wire speed
Use correct torch angle
Check roller tension and adjust as needed. (Section 3.10)
Increase power and wire speed. (Section 4)
Move torch slower and weave a little more
Decrease power and wire speed. (Section 4)
Move torch faster and weave less
Bring torch closer to workpiece
Increase power and wire speed. ( Section 4 )
Bring torch closer to workpiece
Decrease power and wire speed. ( Section 4 )
Move torch faster
Torch distance should be 8-10mm
sales@sealey.co.uk
PURCHASE HERE
www.sealey.co.uk
SUPERMIG230.V2 Issue:1
REGISTER YOUR
08/07/22
Advertisement
