Related Manuals for Sealey SUPERMIG230
Summary of Contents for Sealey SUPERMIG230
- Page 1 INSTRUCTIONS FOR SUPERMIG WELDER SUPERMIG230 MODEL No: Original Language Version SUPERMIG230 Issue No: 3(L) - 24/04/14...
- Page 2 SUPERMIG230 MODEL No: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 3: Assembly And Preparation
ASSEMBLING GAS PLATFORM: (Refer to 'P' in figs.1 & 2) Turn the SPECIFICATION, Model No: ............SUPERMIG230 Welding Current: ..................30 - 230A welder upside down on a smooth non-abrasive surface. The welder should be turned over by two people as it is very heavy. - Page 4 Check welder is switched off “0”, and that the earth clamp is away from the torch tip. Connect the welder to the mains power supply and set the voltage switch to one. fig.11 Original Language Version SUPERMIG230 Issue No: 3(L) - 24/04/14 © Jack Sealey Limited...
-
Page 5: Mig/Mag Welding
3.11.3 Tighten the clutch nut located in the centre of the wire spool holder Sealey “PROSAF/12V OR 24V IN ORDER TO PROTECT SOPHISTICATED ELECTRONICS. ENSURE YOU HAVE READ & with a spanner (fig.7-D) and test the machine as above until the wire stops over running. -
Page 6: Ratings Plate
To keep the contact tip free from spatter, we recommend the use of Sealey anti-spatter spray (MIG/722308) available from your Sealey Dealer. Refer to fig.12 and section 3.9 for removal and replacement. -
Page 7: Troubleshooting
Contact your local solid waste authority for recycling information. Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.