Fax Commands - US Robotics 3CP5613 User Manual

Fax Commands

+FCLASS=n Sets the mode of operation.
FCLASS=0 Data mode
FCLASS=1 Group 3 Facsimile Service Class 1 mode
FCLASS=2.0 Group 3 Facsimile Service Class 2.0 mode
FCLASS? Displays the current FCLASS mode (see
descriptions above).
+FCLASS=? Displays the FCLASS mode options (see
descriptions above).
+FTS=n Stops the fax transmission. Then the
modem waits for a specified time before
OK appears on screen. The pause is set in
10 millisecond intervals. n is the number of
10 millisecond intervals that pass before
OK appears. (n=0-255)
+FRS=n Makes the modem wait for a specified
length of silence before sending OK to
the screen. The pause is set in 10
millisecond intervals. n is the number of 10
millisecond intervals that pass before OK
appears. (n=0-255)
Note: This command terminates with OK when
either the specified amount of silence is
detected or when the user types anything
(which is ignored).
T R
ECHNICAL EFERENCE
+FTM=n
+FRM=n
+FTH=n
+FRH=n
Transmits data using the modulation
specified by n. (n = 3, 24, 48, 72, 96, 97,
98, 121, 122, 145, or 146)
Note: See the "Screen Messages" table at the
end of this section for an explanation of
messages that appear in response to this
command.
Receives data using the modulation
specified by n. (n = 3, 24, 48, 72, 96, 97,
98, 121, 122, 145, or 146)
Note: See the "Screen Messages" table at the
end of this section for an explanation of
messages that appear in response to this
command.
Transmits data framed in the HDLC
protocol using the modulation specified
by n. (n = 3, 24, 48, 72, 96, 97, 98, 121,
122, 145, or 146)
Note: See the "Screen Messages" table at the
end of this section for an explanation of
messages that appear in response to this
command.
Receives data framed in the HDLC
protocol using the modulation specified
by n. (n = 3, 24, 48, 72, 96, 97, 98, 121,
122, 145, or 146)
Note: See the "Screen Messages" table at the
end of this section for an explanation of
messages that appear in response to this
command.
8-21