KTM 450 EXC-F Six Days 2017 Setup Instructions page 7

2 SETUP
(All EXC‑F Six Days)
–
Remove screws
–
Move the handlebar supports to the desired position and mount and tighten
screws
Guideline
Screw, handlebar holder
S01415-10
–
Position the handlebar.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp
S01413-01
–
Position the controls on the right half of the handlebar.
E00468-01
(EXC‑F EU/AU, EXC‑F Six Days EU)
–
Position the controls on the left half of the handlebar.
S01423-01

and take off handlebar supports.

.
M10
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
40 Nm Loctite ®
(29.5 lbf ft)
M8 20 Nm
(14.8 lbf ft)
5
243™