KTM 450 EXC-F Six Days 2017 Setup Instructions page 13

2 SETUP
–
Carefully guide the tail light cable through the frame and in doing so pay atten-
tion to the connector.
–
Position license plate holder on the rear.
–
Mount and tighten screws
E00495-10
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount and tighten screw
Guideline
Remaining screws, chassis
E00489-10
–
Join the plug-in connector of the tail light with the plug-in connector of the turn
signal wiring harness.
–
Mount EFI control unit on the holder.
Guideline
The wiring harness runs under the control unit.
E00498-10
–
Position the main silencer. Mount screws
tighten yet.
–
Attach spring
Spring hook (50305017000)
–
Tighten screws
Guideline
Remaining screws, chassis
E00487-10

.

with the collar bushing.

.

with negative cable and contact disk.

.

.
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)

with the washers, but do not
M6 10 Nm
(7.4 lbf ft)
11