2
SETUP
–
Attach the side cover in area
–
Mount and tighten screw
Guideline
Screw, subframe
–
Mount and tighten screw
Guideline
Remaining screws, chassis
E00494-10
–
Install the battery. (
–
Install the fuel tank. (
–
Position turn signal on both sides, mount and tighten nuts with washers.
–
Position license plate lamp on the license plate holder, mount and tighten
screws
–
Mount reflector
–
Guide cable through the license plate holder.
E00496-10
–
Position license plate holder on the license plate bracket.
–
Join the plug-in connector of the license plate lamp.
–
Join the plug-in connector of the left turn signal which is marked red.
–
Join the plug-in connector of the right turn signal which is marked green.
–
Mount and tighten screws
E00497-10
–
Position the right footrest and pin.
Info
Only insert the pins to the extent that the spring can still be mounted.
D02151-10
and engage it in area
.
M8
.
p. 21)
p. 24)
.
on the license plate holder.
.
.
35 Nm
Loctite
®
(25.8 lbf ft)
M6
10 Nm
(7.4 lbf ft)
12
2701™