KTM 450 EXC-F Six Days 2017 Setup Instructions page 12

2 SETUP
–
Remove screws
–
Carefully remove the tail light cable from the frame and in doing so pay atten-
tion to the connector.
–
Remove license plate holder with tail light to the rear.
S01416-10
–
Remove screws
–
Drill a hole at the marking
E00491-10
–
Route the turn signal wiring harness toward to rear and pass through the frame,
pay attention to the connector when doing so.
–
Route the turn signal wiring harness on the license plate holder and pass the
turn signal wiring harness through the hole.
–
Position the tail light on the license plate holder and mount and tighten
screws
E00492-10

.

and hang the tail light to the side.

the size of the marking.

.
10