KTM 450 EXC-F Six Days 2017 Setup Instructions page 22

3 WORK
3.10 Removing the seat
3.11 Mounting the seat
(All EXC‑F Six Days)
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
K00576-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
S01321-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screws
–
Raise the rear of the seat, pull the seat back, and lift it off.
V00342-10
–
Mount the front of the seat on the collar bushing of the fuel tank, lower the seat at
the rear, and push the seat forward.
–
Make sure that the seat is correctly locked in.
V00343-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
V00342-10

.
p. 18)
 .

.

.
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
p. 17)
M6 10 Nm (7.4 lbf ft)
20