KTM 450 EXC-F Six Days 2017 Setup Instructions page 5

2 SETUP
2.1 Unpacking and setting up the vehicle
Condition
Packaging V2
–
Remove the box and the plastic packaging.
–
Remove the separate enclosure and unpack it. Check that the scope of supply
is complete on the basis of the enclosed packing list.
M00075-10
–
Have a lift stand available.
Lift stand (78129955100)
–
Carefully loosen and remove the tension belt of the footrest mount.
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
402050-01
–
Position turn signal indicator lamp {1} in the speedometer bracket.
–
Remove the headlight mask with the headlight. (
H01768-10
Condition
Packaging V12
–
Remove the box and the plastic packaging.
–
Remove and unpack the separate enclosure and attachments. Check that the
M00075-11
scope of supply is complete on the basis of the enclosed packing list.
–
Remove the two cable ties on the triple clamp.
–
Have a lift stand available.
Lift stand (78129955100)
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a lift stand.
–
Check the vehicle and attachments for transport damage.
–
Install the shock absorber. (
402051-01
Info
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
Info
An assistant prevents the motorcycle from falling over.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
p. 18)
p. 16)
3