KTM 450 EXC-F Six Days 2017 Setup Instructions page 27

3 WORK
3.17 Checking throttle cable routing
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
K00556-10
–
Position the horn with the horn bracket.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
K00558-11
(EXC‑F EU/AU, EXC‑F Six Days EU)
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
–
H01699-10 Lubricate the O-ring and connect plug-in connection
(All US models)
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
–
Lubricate the O-ring and connect plug-in connection
E00517-10
Finishing work
–
Mount the seat. (
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank. (

with the rubber bushing.

with the collar bushings.
 for the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.

for the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
p. 20)
p. 20)
p. 23)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)

for the fuel line.

for the fuel line.
25