Table of Contents
Advertisement
Storingthe ModifiedSettings
(The Write Operation)
Patch settings you modify are temporary, and will return to
theunmodified settings when you select another Patch. If you
wish to keep the modified settings, use the Write operation.
(Procedure)
m
*EJOJEJD3GJCG
Doaa.
Min Lan
rara
[ERE
a S
M
L-
=
r a S
LI
1
When you finish making settings, press [WRITE].
The display shows the destination Patch Number and
Name.
Write to
#1-1-1
TUBE STACE
2
Select the destination Patch Number.
You can specify the destination Patch Number in the
similar way as "Selecting an Effect Sound" (p.12). You can
also specify the destination using the VALUE dial. The
display shows the selected Patch Number and Patch
Name.
* If you wish to store the new settings in the original Patch
number, this step is not necessary.
* Youcannot write it into the Preset Area. If you have edited the
settings in the Preset Area, specify the Patch Number in the
User Area as a destination.
* To cancel the write operation and return to editing, press
[EXIT].
3
Press [WRITE].
The modified settings will be stored in the Patch number
you specified in step 2. When the Write operation is
completed, the Play page will reappear.
Using the Manual Mode
The GT-5 features the Manual Mode that allows you to use
the pedals (1 — 5) as an On/Off selector pedal for the specified
effects. By using this Manual Mode, you can select On/Off of
the specified effect without changing the Patch Numbers.
Changing
to the Manual Mode
< Changing to the Manual Mode with
the Panel Buttons >
Haaga
A
CJ
HOMIE
fw
Each time you press [MANUAL], the Manual Mode will be
turned on or off. When the Manual Mode is turned on, the
display shows the effect that corresponds to each pedal.
« Changingto the Manual Mode with
the Control Pedal >
Each time you press the Control Pedal, the Manual Mode will
be turned on or off. When the Manual Mode is turned on, the
indicator of the Control Pedal is lit and the display shows the
effect that corresponds to each pedal.
When you change On/Off of the Manual Mode using the
Control Pedal, set "Setting the Control Pedal" (p.23) as shown
below.
* You can also control the Manual Mode with Control Assign.
< Quick Seftings >
CTL PEDAL:
P7=MANUAL ON
< Manual Settings >
CTL PEDAL: On
CTL PEDAL Target:
MANUAL On/Off
CTL PEDAL Target Min:
Off
CTL PEDAL Target Max:
On
CTL PEDAL Source Mode:
Toggle
en
enn
steerer
Section 2 Modifying Various Settings
29
Advertisement
Table of Contents
