Table of Contents
Advertisement
1
Get the Control Assign setting you wish to save
into a User Setting to appear in the display.
2 Specifythe destination User Setting. While hoiding
down the Number pedal that corresponds to the
destination (1 — 5), press [WRITE].
The display indicates the name of the User Setting cur-
rently saved.
* Pressing [EXIT] will cancel the saving operation and return to
the condition of step 1.
3
Name the User Setting.
Move the cursor with [PARAMETER], then change letters
with the VALUE dial.
* While changing letters, the following functions can be used:
CAPS: This selects capital or lowercase letters on the
cursor.
INS:
This puts a space on the cursor and shifts the
following letters to right.
DEL:
This deletes the letter on the cursor and shifts the
following letter to left.
4
Press [WRITE].
The contents of the Control Assign will be written into the
User Setting you have selected in step 2 together with the
name information.
Target:
The parameter that will be controlled
Specify the parameter you wish to control. The following
parameters can be selected as targets.
-
Master Level
-
Effect On/Off for each effect
-
Effect unit parameters
-
Tuner/Bypass On/Off
-
Manual On/Off
-
MIDI Start/Stop
-
MMC Play/Stop
* There is some limitation for the parameters that can be set as
targets.
* You may assign two or more controllers to control the same
target, but in this case, avoid using two of these controllers to
simultaneously modify the target parameter. This can produce
noise.
Target Range:
About
the Variable Range of the Target
The values of the parameters selected as targets will vary
between the "minimum" and "maximum" set with the GT-5.
When you are using a controller that selects On or Off, such
as Control Pedal or a footswitch, the value will be "mini-
mum" at OFF (CLOSE) and "maximum" at ON (OPEN).
When you use the controller whose value changes continu-
ously, such as the Expression Pedal, the value will change
between the "minimum" and "maximum."
When it is the
target that selects On or Off, the On or Off will be selected at
the center value of the received message.
HESIGH
1
Min:
Targ
Amount of Change in
Controller
Parameter Value
ON
100%
Max.
Value
Min.
Value
OFF
0%
Amount of Change in
Controller
Parameter Value
Max.
Value
100%
Max.
Value
Min
Value
Min.
Value
0%
Controller
Parameter Value
Max.
Value
ON
Median
Value
Min.
Value
ORE
* The range available for setting will depend on the selected target.
* If you set the "minimum value" above the "maximum value," the
direction of parameter change will be reversed.
* If after setting the "minimum" and "maximum"
values you then
change the target, the settings may change. After changing the
farget, check that the target value range has not changed.
aaar
a
MM
M———
M
MM
M
t
H—Ü
M
MÀ
Section 2 Modifying Various Settings
25
Advertisement
Table of Contents
