Table of Contents
Advertisement
Effect
Turns the modulation effect on/off.
FX Select
This selects the effect to be used from the following ones.
HR; Harmonist:
This effect changes the pitch of the original sound. It is
variable up and down 2 octaves.
FL; Flanger:
Theflanging effect gives a twisting, jet-airplane-like char-
acter to the sound.
PH; Phaser:
By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
SEQ; Sub Equalizer:
This adjusts thetone as a sub equalizer. A parametric type
is adopted for the high-middle and low-middle range.
SDD; Short Delay:
This isthe delay with the maximum delay time of 400 ms.
This effect is efficient for making the sound fatter.
HU; Humanizer:
This can create vowel sounds of the human beings using
the guitar sound.
RM; Ring Modulator:
This creates a bell-like sound by ring-modulating the
guitar sound with the signal from the internal oscillator.
The sound will be unmusical and lack distinctive pitches.
VB; Vibrato:
This effect creates vibrato by slightly modulating the
pitch.
AC; Acoustic Guitar Simulator:
This simulates the sound of an acoustic guitar. You can
obtain an acoustic guitar sound by playing an electric
guitar.
SYN; Guitar Synth:
This detects the pitch of an electric guitar and outputs a
synthesizer sound.
<When "Harmonist' is selected >
Voice
This selects the number of voices for the Pitch Shift sound
(harmony).
1-Voice:
One-voice pitch-shifted sound output in monau-
ral.
2-Mono:
Two-voice pitch-shifted sound (HR1, HR2) output
in monaural.
2-Stereo: Two-voice pitch-shifted sound (HR1, HR2) output
through left and right channels.
Mode
Selection for the Harmonist mode.
Fast, Medium, Slow:
A chord can be input with a normal pitch shifter. The
response is slower in the order of Fast, Medium and Slow,
but the modulation is lessened in the same order.
Mono:
Compared with the conventional pitch shifter, the modu-
lation is minimized. Play in a single note.
Harmony:
This creates Harmony that matches the key of the song
being played. Play in a single note.
« For settings other than Harmony >
Pitch
Adjusts the amount of pitch shift (the amount of pitch change)
in semitone steps.
Fine
Make fine adjustments to the pitch shift.
* The amount of the change in the FINE "100" is equivalent to that
of the PITCH "1."
Pre Delay
Adjusts the time from when the direct sound is heard until the
pitch shifted sounds are heard. Normally you can leave this
set at "Oms."
Feedback
This adjusts the feedback amount of the pitch shift sound.
Level
This adjusts the volume of the pitch shift sound.
Direct Level
Adjusts the volume of the direct sound.
Section 3 Effect Guide
45
Advertisement
Table of Contents
