Table of Contents
Advertisement
Low Cut Filter
The low cut filter cuts the frequencies below the specified
frequency. This setting adjusts the frequency at which the low
cut filter will begin to take effect.
High Cut Filter
The high cut filter cuts the frequencies above the specified
frequency. This setting adjusts the frequency at which the
high cut filter will begin to take effect. When "Flat" is
selected, the high cut filter will have no effect.
Density
This adjusts the density of the reverb sound.
Effect Level
Adjusts the volume of the reverb sound.
MASTER
Master Level
0
100
Noise Suppressor
Effect
Off
On
Threshold
0
100
Release
0
100
Foot Volume
0
100
This determines the Master Level, Noise Suppressor and
Foot Volume.
< Master Level >
Master Level
This adjusts the output volume of the GT-5.
< Noise Suppressor >
This effect reduces the noise and hum picked up by guitar
pickups. Since it suppresses the noise in synchronization
with the envelope of the guitar sound (the way in which the
guitar sound decays over time), it has very little effect on the
guitar sound, and does not harm the natural character of the
sound.
* Please connect the Noise Suppressor prior to the reverberation
type effect. This setup will prevent unnatural break of the
reverberation type effect.
Effect
Turns the noise suppressor effect on/off.
Threshold
Adjust this parameter as appropriate for the volume of the
noise. If the noise level is high, a higher setting is appropriate.
If the noise level is low, a lower setting is appropriate. Adjust
this value until the decay of the guitar sound is as natural as
possible.
* High settings for the Threshold parameter may result in there
being no sound when you play with your guitar volume turned
down.
Release
Adjusts the time from when the noise suppressor begins to
function until the volume reaches "0."
Section 3 Effect Guide
55
Advertisement
Table of Contents
