Panasonic Palmcorder MultiCam PV-DV203 Operating Instructions Manual page 15

Li,
1
2
CHARGE Lain 3
Connect and plug in the Power Cord
as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached,
from the adaptor.
Attach the Battery as shown to
charge.
• CHARGE Lamp lights up. it goes out
when charging is complete (approx.
1 hour). Expect approx. 1 hour
50 minutes of operation (using EVF )
when fully charged.
Remove the Battery.
Slide the Battery out and then lift up.
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of 10 °C (50 °F) and
30 "C (86 °F).
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is taking longer than normal
• Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
|_(_il [ ,ITL:i | _
:15"I |(:] d , Y J",_
I iiI:t=liii ill -"F;ltl_i, rl ",_
Insert the Battery Pack and slide it up
until it locks with a click.
RELEASE
While sliding the BATTERY RELEASE,
slide the Battery downward and
remove.
15