Panasonic Palmcorder MultiCam PV-DV203 Operating Instructions Manual page 10

You can c0ntrol any two Panasonic
Palmcorders with one Remote Contro_
dOPtioeal), in order for the remote to
istinguish between the two units, it ;s
necessary to set one of the Palmcerders to
VCR 2. On the remote, press VCR I or
VCR 2 to control the desired P_Imcorder.
2MEN_
For VCR 2: For VCR 1:
Press these 7Press these
buttons at the
same time, same time.
m
* Whert the PaJmcorder and remote are
net set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE) will appear,
1
3
4
5
Set POWER to VCR or CAMERA.
• The POWER Lamp lights red_
• Be sure POWER is tully turned to
VCR or CAMERA position.
Press MENU to d)sp)ay the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to select_
in the CAMERA or VCR
mode menu screen, then press JOG
KEY to display the OTHER
FUNCTIONS menu screen.
Rotate JOG KEY to select
and then press JOG KEY to select
VCR 2 (Menu OSD: pp. 109, 111).
Leave the other Palmcerder set to
VCR1.
Set the Remote Control to VCR 1 or
VCR 2 t_ correspond with the
Pelmcorder you wish to control. (See
above/eft,)
* After repiecing the Remote Control
Battery, the retools will default to VCR 1.
10