Audi A4 2023 Owner's Manual page 52

Opening and closing
Applies to: vehicles with garage door opener
Requirements: the remote control transmitter
must be programmed © page 50, Program-
'ming, the vehicle must be within range of the
system, and the ignition must be switched on.
There are multiple options to open or close the
system (such as the garage door).
» To display the -@ button (Garage door opener)
for the garage door opener, press the =] but-
ton in the status bar © page 22.
» If you have only programmed one remote con-
trol transmitter, press the - button in the sta-
tus bar on the center display page 20. Or
> If you have programmed multiple remote con-
trol transmitters, press the @ button in the
status bar on the center display page 20 and
then press the button for the respective sys-
tem. Or
> Applies to: vehicles with programmable steer-
ing wheel button: If you have configured the
programmable steering wheel button, press
the 2 button © page 29. Or
> Applies to: vehicles with GPS pairing: If you
have programmed Location pairing, press the
respective button in the center display (notifi-
cation center > page 22). As you approach the
system, the button is displayed on the MMI. Or
> When reverse gear is selected, the parking sys-
tem* / rearview camera* / peripheral camera*
will appear in the center display. To display the
buttons of the first three garage door openers,
press the =] button in the status bar and then
press the button for the respective system.
If transmission was successful, the message:
Send to: XXX will appear.
Programming
Applies to: vehicles with garage door opener
You can program both fixed code and rolling code
systems in the MMI using the procedure that is
described.
Requirement: the ignition must be switched on.
D Only applies to rolling code systems
50
Programming the system
Applies to: MMI
Requirement: the hand transmitter must be
present and the vehicle must be within range of
the system (such as the garage door) that you
would like to program. If you program more than
three remote control transmitters, assign the
first three spots to the systems that you would
also like to use when driving in reverse.
» To display the - button for the garage door
opener, press the [=] button in the status bar
© page 22.
> If you are programming the garage door opener
for the first time, press the -@ button on the
center display. Follow the instructions in the
MMI. Or
> If you would like to program other systems, se-
lect on the home screen: VEHICLE > Settings &
Service > Garage door opener. Select the de-
sired button: @). Follow the instructions in the
MMI.
> If you would like to reprogram systems that are
already programmed, select on the home
screen: VEHICLE > Settings & Service > Garage
door opener. Press the 4 button and select 7
for the system to be reprogrammed. Select:
Program. Follow the instructions in the MMI.
With some systems, the garage door opener will
be immediately available after programming.
With other systems, the garage door opener
must also be synchronized.
Synchronizing"
Requirement: the hand transmitter must already
be programmed and the vehicle must be within
range of the system (such as the garage door).
If the system synchronization is performed di-
rectly after the programming procedure, follow
the instructions on the MMI.
If you would like to sync at a later time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage door
opener.