Table of Contents
Advertisement
Bit
3
Not used
4
Not used
5
Redial function when transmission error occurs
6
Not used
7
Error report when sending process is canceled
Detailed Discussions of Bit 2
Select whether to display a confirmation message when entering destination for the sequential broadcast in order to prevent
the user from broadcasting by mistake.
Detailed Discussions of Bit 5
Select whether to use the redial function when outgoing transmission error occurs.
Detailed Discussions of Bit 7
Select whether to output an error report when the [Stop] key is pressed to cancel sending.
■ SSSW-SW28
Functional Configuration
Bit
0
V.8 procedure at the caller side
1
V.8 procedure at the receiver side
2
V.8 late start at the caller side
3
V.8 late start at the receiver side
4
Fallback from the V.34 receiver side
5
Not used
6
Not used
7
Not used
Detailed Discussions of Bit 0
Select whether to execute V.8 procedure when making a call.
"No": V.8 procedure is not executed even if V.8 procedure is received from the receiver side, and the procedure starts from
V.21.
Detailed Discussions of Bit 1
Select whether to execute V.8 procedure when receiving a call.
"No": V.8 procedure is not executed, and the procedure starts from V.21.
Detailed Discussions of Bit 2
Select whether to execute V.8 procedure when ANSam signal from the receiver side cannot be recognized at the time of
making a call and V.8 procedure is declared by DIS signal from the receiver side.
"Yes": CI signal is sent in response to the DIS signal of the receiver side to execute the V.8 procedure.
"No": CI signal is not sent in response to the DIS signal of the receiver side, and the V.21 procedure is executed.
In the case of manual transmission, there will be no V.8 late start regardless of this setting.
Detailed Discussions of Bit 3
Select whether to declare the existence of the V.8 procedure with the DIS signal that is transmitted after the ANSam signal
in case that the ANSam signal at the reception is not recognized at the caller side.
"Yes": V.8 procedure is declared by DIS signal and V.8 procedure is executed after CI signal is sent from the caller side.
"No": V.8 procedure is not declared by DIS signal, and V.21 procedure is executed.
In the case of manual transmission, there will be no V.8 late start regardless of this setting.
Detailed Discussions of Bit 4
Select whether to prohibit fallback from the V.34 receiver side.
"Prohibit": There will be no fallback from the receiver side.
Function
Function
29
5. Service Mode
1
-
-
Use
Do not use
-
Do not output
Output
1
No
No
No
No
Prohibit
Do not prohibit
-
-
-
0
-
-
-
0
Yes
Yes
Yes
Yes
-
-
-
Advertisement
Table of Contents
