Table of Contents
Advertisement
Trouble shooting
The product shows incorrect/no air flow
• Make sure that the product is energized.
• Check that the product's set size corresponds with the
physical size.
• Make sure that the product is installed according to the
recommended distance to disruptions, see "Installation".
• Check that there is an air flow.
• Make sure that the product is correctly oriented in terms
of air direction. The air flow must follow the instructions
on the product.
• Check that the measuring tube is mounted correctly,
plus to plus (red), minus to minus (blue).
• Check that the measuring tubes are undamaged and
not creased.
• Check with the help of the k-factor and pressure
difference between the red and blue measuring tubes
that the flow is within the product's measurement
range.
The product does not regulate the air flow
• Make sure that the product is energized.
• Check that the damper motor has not become
detached from the damper spindle.
• Check that the damper motor works by pressing in the
motor's release button, turn the damper spindle, release
the release knob and then see whether the damper
motor starts to move.
• Check that the product is connected correctly.
• Check that the product is not force controlled.
The product does not regulate on the desired air
flow
• Check that the settings for Vmin and Vmax correspond
with the required regulation range.
• Check the electrical connection for the required
function, see the wiring diagram in the document
"REACT Belimo Description of functions & wiring
diagram".
• Check that the product is connected correctly, check
the "Y" signal and polarity on "G" and "G0". See
"Connections".
Cleaning
Ideally, the product should be cleaned in connection with
the cleaning of the rest of the ventilation system.
Cleaning of electrical components
• If needed, use a dry cloth to clean the components.
• Never use water, detergent and cleaning solvent or a
vacuum cleaner.
External cleaning
• If necessary use tepid water and a well-wrung cloth.
• Never use detergent and cleaning solvent or a vacuum
cleaner.
Internal cleaning
• When cleaning the ventilation system, the product
must be dismantled if there are no cleaning hatches
close to the product.
• Cleaning equipment such as whisks and the like must
not be fed through the product.
• If necessary remove dust and other particles that can
be present in the product.
• Never use detergent and cleaning solvent or a vacuum
cleaner.
Service/maintenance
• The product does not require any maintenance, except
for any cleaning when necessary.
• In connection with a service, mandatory ventilation
inspection or cleaning of the ventilation system, check
that the general condition of the product appears to be
good. Pay particular attention to the suspension, cables
and that they sit firmly in place.
• It is not permissible to open or repair electrical
components.
• If you suspect that the product or a component is
defective, please contact Swegon.
• A defective product or component must be replaced by
an original spare part from Swegon.
Materials and surface treatment
All sheet-metal parts are galvanized sheet steel (Z275).
Disposal
Waste must be handled according to local regulations.
Product warranty
The product warranty or service agreement will not be
valid/will not be extended if: (1) the product is repaired,
modified or changed, unless such repair, modification
or change has been approved by Swegon AB; or (2) the
serial number on the product has been made illegible or
is missing.
20230929
Swegon reserves the right to alter specifications.
REACT V BMP
9
Advertisement
Table of Contents
