Bulb Replacement - universalblue ALPES 4010W User Manual

ENGLISH
grain of the stainless steel to prevent any
unsightly crisscross scratching patterns
from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned
using warm soapy water. Ensure the cloth
is clean and well wrung before cleaning.
Use a dry soft cloth to remove any excess
moisture left after cleaning.
Important
Using neutral
using harsh cleaning chemicals, strong
household detergents
containing abrasives,as this will affect
the appearance
potentially remove
artwork on the control panel and will void
manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand.
Soak them for about 3 minutes in water
with a mild detergent and then brush it
gently with a soft brush. Please do not
apply too much pressure so as to avoid any
damage to it . (Leave to dry naturally out of
direct sun light)
Filters should be
to crockery and kitchen utensils.It is
advisable not to use rinse aid.
(Image J, page 6 of the manual)
32 = First step
33 = Second step
34 = Third step
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps:
- Angle the filter into the slots at the back
of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into
a resting position.
- Repeat to install all filters.
26
detergents and
or products
of the appliance and
any printing
washed separately

BULB REPLACEMENT

• The bulb must be replaced by the
manufacturer, its service agent or
similarly qualified persons.
• Always switch off the electricity supply
avoid
before carrying out any operations on
the appliance. When handling bulb,
make sure it has completely cooled
down before any direct contact with
hands.
of
• When handling bulbs hold with a cloth
or gloves to ensure perspiration does
not come in contact with the bulb as
this can reduce the life of the bulb.
Note:
• Before changing the lights, make sure
that the appliance is turned off and
unplugged.
• Protect against danger when changing
lights, such as wearing gloves.
Changing the lights:
1. Open
remove the grease filter.Dismanble
the panel baffle assembly,take out the
terminal base of light wire and switch
wire.
2. Use the screw driver loosen 8pcs
ST4*8MM self tapping screw from
the lighting panel, take out the panel
baffle.
3. Take out the light strip and replace it.
4. Apply the reverse procedure to install
the light strip back.
• ILCOS D code for this lamp is: DSL-4-S-350
– LED modules–lamp strip
– Max wattage: 2×4 W
– Voltage range: DC 12V
– Dimensions: length:350mm
(Images P and Q, page 7 of the manual)
Important :
the decorative glasses,and