Installing The Product - universalblue ALPES 4010W User Manual

ENGLISH
INSTALLATION
MOUNTING OF THE V-FLAP
(VENT OUTSIDE)
If the cooker hood does not have an
assembled V-flap 1, you should mount the
half-parts to its body. The images only show
an example of how to mount the V-flap,
because the outlet may vary according to
different models and configurations.
To mount the V-flap 1 you should:
• Mount two half-parts (16) into the body
(20).
• The vertical pin (17) should be top oriented.
• The axis (18) should be inserted into the
holes (19) on the body.
• Repeat all the operations for the 2nd half-
part.
(Images A and B, page 5 of the manual)

INSTALLING THE PRODUCT

1. Before installation, turn the unit off
and unplug it from the outlet.
2. The cooker hood should not be placed
at a distance of no more than 150cm
from the cooking surface for the best
performance.
3. The ceiling must can bear at least
120KGs weight, and the thickness of
the ceiling must be ≥30 mm.
(Images C and D, page 5 of the manual)
21 = Ceiling
22 = Ceiling decorative board
23 = Ceiling decorative board, Opening
size: 630 x 560 mm
24 = Hole diameter: 8mm
4. Drill 14pcs φ8mm holes on the
ceiling once the installation height
is determined, 14pcs explode screws
(or 14pcs of ST6*40mm big flat
screws+14pcs wall plugs) will be used
to fix the two hanging board on the
22
ceiling.
(Image E, page 5 of the manual)
25 = Hanging board
5. Calculate the length of the angle
iron, then 32pcs of M4*10 screws
and M4 nut with gasket will be used
to connect the angle iron into the
adjustable angle iron bracket. (Make
sure the overlap length of angle iron
cannot less than 36mm).
(Images F and G, page 5 of the manual)
26 = Adjustable angle iron bracket
27 = Angle iron
28 = Total length of angle iron: C=A-B
6. Choose the direction of the outlet
• Open the
order,and take out the filter.
• Unscrew and take away the 4 pcs
ST4*8mm screws that on the panel
baffle assembly.
• Unscrew the 8pcs machine silk from
the bottom of the cabinet housing
and rotate it by 90°/180°/270° to
choose the direction of the outlet,
then screw the 8 pcs machine silk to
fix the housing well.
• Install the panel decorative strip and
filter well apply to the reverse order
of a/b steps above, meanwhile, install
the expansion pipe to the outlet.
(Images H, I, J and K, page 6 of the manual)
29 = Expansion pipe
30 = First step
31 = Second step
32 = First step
33 = Second step
34 = Third step
35 = First step
36 = Second step
37 = Third step
38 = Fourth step
7. Connect the 4 adjustable angle iron
bracket with the housing by 8pcs
M4*12mm
next lift up the housing, use 8pcs
decorative plate
machine silk
in
screw,