universalblue ALPES 4010W User Manual page 24

ENGLISH
START USING YOUR COOKER HOOD
Connecting the remote control
A new remote control has to establish a
new connection to the cooker hood when
used for first time. One remote control
could possibly control several cooker hood
at the same time.
Connection process
control and cooker hood
• Within 15s after the cooker hood
connects to the power supply, long
press for 5 seconds, the indicators
24
On/Off
Light
Ventilation speed
Timer
between remote
Switches the ventilation on and off
Switches the light on and off. Please note
lamp is not under control of the on/off
button
The motor has the low speed, mid. speed
and high speed.
When the hood is working with low speed,
LED display will show 1.
Press the button, then the hood will
transfer to the mid speed for working; the
LED will show 2 , press the speed button
again , the hood will transfer to the high
speed for working immediately. And so
on...
This is a 9 minute timer. When the hood
is working, press this button to set a time
for motor operation. press the button
,LED display will be shown 9.8.7.6 until
0, When LCD shows 0, the hood will
be off automatically and the lamp will
extinguish. If keep pressing "Timer"
button, the hood will go in or go out
"Timer" function.
light begin flashing from one button
to another ,the cooker hood is in
connection mode, press any button
on remote control to confirm the
connection. The connection process
finished and the remote control can be
used for speed selection, lighting and
timer setting.
• If you want to connect again, you will
need to clear the code that has been set
up previously.
• To clear the code, press
seconds, the indicators light begin
flashing from one button to another, the
for 5