universalblue MARMARA User Manual page 66

Engine noise
Foam in the
tray
Incorrect detergent
Stains inside
the
dishwasher Incorrect detergent
Incorrect program
Dirty
crockery and Placing the correct
cutlery tableware
Water too hard
Low water
temperature
Overloading the
Stains on
dishwasher
glassware or
cutlery
Placing the correct
tableware
Empty salt and rinse
dispenser
Incorrect detergent
dispenser
Combination of too
Fogged soft water and too
glassware much detergent
Brown or
yellow film
on the
bottom of the Remains of coffee or
cups tea
Detergent
dispenser
does not
close Remains of detergent
The dishwasher has not been used regularly. In that case, try to turn it
on at least once a week to ensure proper operation.
Use only detergents designed for the dishwasher. If foam is detected
it is recommended to open the dishwasher door and wait until the
foam disappears.
Add 1 litre of cold water to the flask, close the dishwasher and start
the appliance with the pre-wash program.
Make sure that the detergent used is suitable and does not contain
dyes.
Select a more intense program
Place the tableware correctly as shown in the corresponding section.
- Remove all metal utensils from the appliance
- Do not add detergent-
Select the longest program-
Let the program run for 18 to 22 minutes-
Open the door and add 2 cups of vinegar at the bottom of the
appliance-
Close the door again and let the dishwasher finish the program-
If it does not work repeat the process with lemon juice instead of
vinegar.
Use less detergent and use shorter programs to wash glassware
Let the cup soak in warm water and liquid detergent before putting it
in the dishwasher.
Clean the dispenser and make sure that there are no traces of
detergent in the slots.
66