universalblue MARMARA User Manual page 44

 Once the appliance is installed, the power cord and power outlet should be easily
accessible.
 The cable must not be bent or compressed.
 If the power cord is damaged, it must be replaced by the manufacturer or a
professional.
 The company is not responsible for incidents that occur when the user fails to
comply with any of the requirements set out in this manual.
HOW TO DRAIN EXCESS WATER FROM HOSES
If the sink is 1000 mm higher than the floor, excess water in the hoses cannot be drained
directly into the sink. Excess water will need to be drained from the hoses to a suitable
container lower than the sink.
ADVICE ON THE FIRST WASHING CYCLE
Once the appliance is installed, before starting the first washing cycle, it must be
completely cleaned, fill the salt tank and rinse aid dispenser. The water may overflow
when filling the salt dispenser but don't worry as this is completely normal. It is also
common for the salt indicator light to continue flashing as low/low for a few cycles after
the dispenser has been filled.
Before starting the dishwasher, check the following:
 If the dishwasher is level and fixed
 If the inlet valve is open
 If there are leaks in the duct connections
 If the cables are properly connected
 If the power is connected
 If the inlet and outlet hoses are properly installed
 All packaging and printing materials must be removed from the dishwasher.
44