universalblue MARMARA User Manual page 48

No salt is required at the set value H0.
To adjust the descaler, follow the steps below:
1. Find out the tap water hardness value. Your water authority will be able to help you
with this.
2. The set value can be found in the water hardness table below.
3. Once adjusted, close the dishwasher door.
4. Press the "Power" button.
5. Press and hold the "Delay" button and press the "Program" button for 5 seconds. The
device will beep once and the indicator 'H' will appear on the display (H4 is the factory
default).
6. To change the value, press the "Delay" button as many times as necessary until the
desired value is set. Each time the button is pressed, a level is increased. When the
value reaches H7, pressing H0 again jumps the display.
7. Press the " Program " button to store the selected value.
Hardness grades
0-8
9-10
11-12
13-15
16-20
21-26
27-38
39-62
FILL THE SALT TANK
Always use salt for the dishwasher. The use of salt will help prevent corrosion of the
tank.
Attention!
Use only salt specially designed for dishwasher use. All other types of salt not
specifically designed for use in the dishwasher (especially table salt) will damage the
water softener. In case of damage caused by improper use of salt, the manufacturer is
not responsible for the damage caused and the dishwasher will lose the warranty.
The salt container is located below the bottom basket and should be filled just before
starting one of the complete wash programs. To fill it out, follow the steps below:
Water hardness
Range
Soft
Soft
Medium
Medium
Medium
Hard
Hard
Hard
Mmol/l
0-1.1 H0
1.2-1-4 H1
1.5-1.8 H2
1.9-2.1 H3
2.2-2.9 H4
3.0-3.7 H5
3.8-5.4 H6
5.5-8.9 H7
Value to set in the
dishwasher
48