Stiga AM 98 Li 48 V1 Operator's Manual page 275

9. The icon (fig. 9.F) remains
lit and the battery LEDs 1,3
and 5 continue to flash.
Pushbutton panel type "I"
and "II"
Pushbutton panel type
"III"
10. The icons (fig. 9.F) and
(fig. 9.L) remain lit and the
battery LEDs 1, 2 and 4
continue to flash.
Pushbutton panel type "I"
and "II"
Pushbutton panel type
"III"
11. The icons (fig. 9.F) and (fig.
9.l) remain lit and the battery
LEDs 1, 2, 4 and 5 continue
to flash.
Pushbutton panel type "I"
and "II"
Pushbutton panel type
"III"
Cutting means motors
stalling due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
Overheating of the drive
motor due to:
1. Drive motor under
strain.
2. Slope too steep.
3. Excessive presence
of mud on the wheels.
The machine is started
with the direction lever
(fig. 8.D.1) not released
(not in neutral position).
EN - 29
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.
Turn off the machine and wait at least 5 minutes
before repeating the start-up procedure.
Reduce the travel speed
Reduce the speed and check the gradient of the
slope you are working on.
Make sure the wheels are not blocked and clean
them if necessary.
Turn the machine off and repeat the starting
procedure only after making sure that the direction
lever (fig. 8.D.1) is in neutral (par. 6.4.1).