Stiga AM 98 Li 48 V1 Operator's Manual page 248

1. GENERAL INFORMATION
1.1 HOW TO READ THE MANUAL
Some paragraphs in the manual contain important
information regarding safety and operation and
are emphasized in this manner:
DANGER
Failing to comply with the cautionary note
creates a situation of imminent risk which, if not
avoided, may result in instant death or severe or
permanent harm.
CAUTION
Failure to comply with the warning signal will
result in a situation of imminent risk which, if
not avoided, will cause death or severe harm to
health.
WARNING
Failure to comply with the warning signal will
result in a situation of imminent risk which, if
not avoided, may cause minor machine-related
damage.
NOTICE
It provides an instruction referring to a necessary
approach to deal with practices that are not
related to physical injury.
SAFETY INSTRUCTIONS
It provides an instruction referring to specific
procedures to be followed in the event of
situations endangering human health or machine
safety.
NOTE
Provides additional information to previous safety
message instructions.
The paragraphs inside a grey dotted frame
refer to optional features not available on all
the models referred to in this booklet. Check if
the feature is available on your model.
Whenever reference is made to a position on the
machine "front", "back", "left" or "right" hand side,
this refers to the operator's working position.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for use are
numbered 1, 2, 3, etc.
The components indicated in the figures are
identified with letters A, B, C, and so on.
Reference to component C in figure 2 is indicated
with the wording: "See fig. 2.C" or simply
"(fig. 2.C)".
The figures are given as a guide only. The actual
pieces can differ from those illustrated in this
document.
1.2.2 Titles
The manual is divided into chapters and
paragraphs. The title of paragraph "2.1 Training"
is a subtitle of "2. Safety regulations". References
to titles or paragraphs are marked with the
abbreviation chap. or par. and the relevant
number. Example: "chap. 2" or "par. 2.1"
2. GENERAL SAFETY WARNINGS
2.1 GENERAL SAFETY WARNINGS
WARNING
Please read all safety warnings, instructions,
illustrations and specifications provided with
the machine. Failure to follow the instructions
listed below may result in electric shocks, fire
and/or severe injuries.
Save all warnings and instructions for future
reference.
The term "power tool" mentioned in the warnings
refers to your machine using mains power supply
(with cable) or battery power supply (without
cable).
1) Work area safety
a) Keep the work area clean and well lit.
Cluttered or poorly lit areas make accidents
more likely to happen.
b) Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases
or dust. Power tools create sparks which
may ignite the dust or fumes.
c) Keep children and bystanders at a safe
distance while operating a power tool.
Distractions can cause you to lose control.
EN - 2