Toggle Qnh Hpa - Inhg; Toggle Illumination Knob - Kanardia INDU Manual

Altimeter — Manual
3.3 Toggle QNH hPa – inHg
1020 1025
Part of the LCD display is also a QNH value. This value can be shown in
hPa or in inHg units. You can change the units using next procedure:
1. Turn the knob until it shows 1020 hPa (30.12 inHg) and wait for about
three seconds for a short cyan line to appear on top of LCD display.
2. Quickly turn the knob to indicate 1025 hPa (30.27 inHg). A moment
later a longer cyan line appears.
3. Turn the knob to 1013 hPa (29.91 inHg) to complete the procedure.
Observe the units and values next to QNH. They changed from hPa to
inHg and vice versa.
3.4

Toggle Illumination Knob

1020 1035
This section applies only to instruments without push/rotate knob.
If the external illumination knob does not work – screen does not react on the
knob, try the following procedure. This procedure enables remote illumination
knob if it was not enabled or disables illumination knob, if it was enabled.
1. Turn QNH until it shows 1020 hPa (30.12 inHg) and wait for about
three seconds for a short cyan line to appear on top of LCD display.
2. Quickly turn the knob to indicate 1035 hPa (30.56 inHg). A moment
later a longer cyan line appears.
3. Turn the knob to 1013 hPa (29.91 inHg) to complete the procedure.
4. Finally, you need to turn off Indu Altimeter and then back on in order
to activate the change.
1013 for hPa or 30.12
1013 for hPa or 30.12
16
3.3 Toggle QNH hPa – inHg
30.27 29.91 for inHg.
30.56 29.91 for inHg.
© Kanardia 2015-2020