Table of Contents
Advertisement
1). Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2). Loosen the T screw to adjust the tilt position [0°
to 90°]. Tighten the screw after completing the
adjustment.
3). Loosen the R screw and rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
Rotation Position Range
[0° to 360°]
2.1.2 Ceiling/Wall Mounting with Junction Box
Note:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole in the
ceiling/wall according to the holes of the drill
template.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box' cover.
4. Fix the camera on the junction box's cover with
supplied screws.
Figure 2-5 Fix the camera on the junction box's cover
5. Attach the junction box body to the ceiling/wall by
aligning the screw holes of the junction box.
6. Secure the junction box's body with supplied screws
on the ceiling/wall.
Figure 2-3 3-axis Adjustment
Figure 2-4 Drill Template
Pan Position Range
[0° to 360°]
P Screw
Tilt Position Range
[0° to 90°]
T Screw
R Screw
Unit mm
Advertisement
Table of Contents
