Advertisement
(2) Attach the accessory weights 35° both ends of the
knitted piece.
(3) Set the carriage,
following the instructions
in the
operation table.
(4) To prevent the knitted pattern from being shaped
wrong, bring one
end needle
to the D position on
the carriage side and hook the threading yarn onto
the yarn holder on the arm in the direction in which
the carriage is to be moved.
(5) Knit one row, moving the carriage in the direction
indicated by an arrow.
(6) Bring a needle on the side with the carriage on to
D position
and
change the threading yarn to the
yarn holder on the arm in the direction in which the
carriage is to be moved and continue knitting.
(7) Move the carriage from left to right.
(8) Continue knitting, changing threading of yarn each
time until STOP sign appears in the pattern panel
window
and
you
hear
the
Buzzer.
(The
needle
nearest to the carriage is to be brought out to D
position before you knit each row.)
(9) Return
the card from STOP back to the ==
mark.
(10) Knit one row,
following the instructions
in the
=
mark line indicated by a red arrow.
(11) Continue knitting, repeating the process of procee-
ding from 0 to STOP
and back to the
=
mark
indicated by a red arrow.
| Note: * Set the Russel
lever to the right (red) for
operating the needles pulled to the D po-
sition at the end of the knitted fabric.
|
* The
tension
dial
must
be adjusted
as
follows for the threading yarn.
Medium yarn
Thick yarn
\ aa
|
Advertisement
