Starting and Shutting down the Projector
1.
Remove the lens cap.
2.
Securely connect the power cord and
signal cable. When connected, the power
led will turn red.
3.
Turn on the lamp by pressing "
button on the rear of the projector or
"
" on the remote control.
The PWR LED will now flash red.
The startup screen will display in
approximately 30 seconds. The first time
you use the projector, you can select
your preferred language from quick menu
after the startup screen display. (See
Setting the OSD Language
See
Setting an Access Password
(Security Lock)
is enabled.
"
on page 34)
on page
24
if security lock
— 22 —