Led Error Messages; Image Problems - Vivitek DX5630 Series User Manual

LED Error Messages

E C
RROR ODE
Standby
Start warm up
Lamp Ready
Cooling
Over Temperature
Thermal Break Sensor error
Lamp strike fail / ballast connector open
Lamp voltage too low
Ballast fail
Ballast communication fail
Ballast over temp
Lamp fail
Fan 1 error
Fan 2 error
Fan 3 error
Fan 4 error
Fan 5 error
Fan 6 error
Fan 7 error
Case Open
DMD error
T1 error
T2 error
Color wheel error
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting the projector. If
the Power or Ready LEDs are still blinking or any other situation that isn't listed in the chart above, please contact your
service center.

Image Problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.
M
ESSAGES
P L T
OWER ED EMP
Red
Flashing(Red)
Green
Flashing(Red)
OFF
4 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
6 blinks
6 blinks
6 blinks
6 blinks
6 blinks
6 blinks
6 blinks
7 blinks
8 blinks
8 blinks
8 blinks
9 blinks
— 75 —
L R
ED EADY
OFF OFF
OFF OFF
OFF ON
OFF OFF
ON OFF
OFF OFF
OFF OFF
OFF 7 blinks
OFF 8 blinks
OFF 10 blinks
OFF 11 blinks
OFF 14 blinks
OFF 1 blinks
OFF 2 blinks
OFF 3 blinks
OFF 4 blinks
OFF 5 blinks
OFF 6 blinks
OFF 7 blinks
OFF OFF
OFF OFF
OFF 1 blinks
OFF 2 blinks
OFF OFF
L
ED