Starting And Shutting Down The Projector - Vivitek DW83BAA User Manual

Starting and Shutting down the Projector

1.
Connect the power cord to the
projector. Connect the other end to
a wall outlet.
The POWER LED on the
projector light.
2.
Turn on the connected devices.
3.
Ensure the POWER LED not a
flashing. Then press the
button to turn on the projector.
The projector splash screen displays
and connected devices are
detected.
See Setting an Access Password
(Security Lock)
security lock is enabled.
4.
If more than one input device is
connected, press the SOURCE
button and use ▲▼ to scroll among
devices.
(Component is supported through
the RGB to COMPONENT
ADAPTER.)
Note:
After powered on for 3 minutes,
the projector goes into the ED
(Extreme Dimming) mode if the
source cannot be detected within
30 seconds.
POWER
on page 13 if

VGA1 / VGA2: Analog RGB

Composite Video: Traditional composite video

S-Video: Super video (Y/C separated)

HDMI 1: High-Definition Multimedia Interface 1

HDMI 2/MHL: High-Definition Multimedia Interface 2
/MHL
– 11 –