Blade Replacement; Tool Maintenance; Battery Maintenance - Nakayama Pro EC1300 Instruction Manual

EN

Blade replacement

Disconnect the power to the scissors before such a task
Remove the battery to ensure safe working conditions and replace the blade step by step as shown below.
1. Unscrew the screws with a
screwdriver and open the lid.
4. Unscrew the pin and remove
the moving blade
7. Replace each blade.
After replacement, clean the tool, turn it on to test it and close the blade to finish.
MAINTENANCE

Tool maintenance

1. Do not use the tool for cuts outside the cutting range or for non-plant materials such as metals, stones, etc. Do not use it as a vise clamp for clamping tools.
Replace a cutting blade immediately if it is worn out or damaged.
2. Please keep all equipment clean, use a dry, clean cloth to clean the blades, batteries and chargers (do not use corrosive or solvent detergents) and use a soft
brush or dry cloth to remove dust from the top of the scissors.
3. Do not soak electric pruning shears, batteries or chargers in water or any other liquids.
4. Please use equipment correctly, as instructed. Immediately stop using if there is any damage on the electric shears, batteries or charger.
5. If the switch does not work properly, do not use the electric pruning shears. Using the electric pruning shears without a switch can be extremelly dangerous
and the tool must be placed under repair.
6. Make sure that the switch is turned off while replacing parts or when storing the electric pruning shears. Such a preventive measure will reduce the risk of
the accidental starting of the tool.
7. Store and keep the electric pruning shears away from children to avoid accidents. It is also dangerous to let inexperienced or untrained users to operate the
electric pruning shears.
8. When using the electric pruning shears, follow the appropriate operating instructions and make sure that the weather conditions are suitable for work.
Damage or injury can result from improper use of the tool.
9. After each use, remove any dirt from the moving blade and shim, add lubricating oil to the contact point and follow all blade maintenance instructions to
ensure the shears are ready for each subsequent use and to extend their lifespan.

Battery maintenance

1. Do not charge the batteries in an environment below 0°C and above 45°C, damage to the batteries and/or chargers may occur.
2. Make sure the switch is turned off before connecting the battery. If the switch is on, an accident may occur.
3. Use only the chargers specified by the manufacturer to charge the batteries. Chargers with non-compatible batteries pose a fire hazard when charging.
4. When batteries are unused, please move them away from tiny metal objects such as paper clips, coins, keys, nails and screws, which can shorten their
lifespan.
5. Short-circuiting a battery may result in a burn injury and present a fire hazard.
6. Do not disassemble or rebuild batteries.
7. Do not use short-circuit batteries.
8. Do not charge around a heat source.
4
2. Remove the screws from the
blade nut retaining buckle (this
step is critical).
5. Remove the fixed blade
8. Insert nut.
WWW.NIKOLAOUTOOLS.GR
3. Remove the blade nut.
6. When replacing the blades,
lubricating oil needs to be added
in between.
9. Insert the lock nut.