Post-Installation Check; Wiring - Endress+Hauser RIA15 Operating Instructions Manual

RIA15
Endress+Hauser
 3 Mounting the process indicator on a wall
1. Use the mounting plate as a stencil for 2 6 mm (0.24 in) bore holes, 82 mm (3.23 in)
apart, and secure the plate on the wall with 2 screws (not supplied).
2. Open the housing.
3. Secure the indicator on the mounting plate with the 4 screws supplied.
4. Close the cover and tighten the screws.
4.3

Post-installation check

4.3.1 Display unit in the panel-mount housing
• Is the seal undamaged?
• Are the mounting clips securely fastened on the housing of the device?
• Are the threaded rods properly tightened?
• Is the device located in the center of the panel cutout?
4.3.2 Display unit in the field housing
• Is the seal undamaged?
• Is the housing firmly screwed to the mounting plate?
• Is the mounting bracket firmly secured on the wall/pipe?
• Are the housing screws firmly tightened?
5

Wiring

WARNING
L
Danger! Electric voltage
‣
The entire connection of the device must take place while the device is de-energized.
1.
2.
3.
Wiring
A0017803
11