PCE Instruments PCE-AQD 50 User Manual page 40

After selecting Time format or Date format, the device w ill display highlight the value to be
modified in w hite. The user can change the value w ith the arrow keys ▲ and ▼. The possible
values for the time format are 24h and 12h and the options for the date format are dd.m m.yyyy,
dd/m m/yyyy, mm.dd.yyyy, mm/dd/yyyy, yyyy.mm.dd and yyyy/mm/dd. Once the f or mat is
selected, the OK key must be pressed.
Note:
If 12h is selected for the Time format, the time w ill be displayed w ith am/pm.
Fig. 55 Time format change
Fig. 56 Date format change
5.4.3.3 Alerts submenu
Via this submenu, you can enable/disable and define an alarm for each measured variable. In
case the measured value for a certain variable exceeds the limit set in the alert, the dev ic e w ill
beep every 2 seconds for a duration of 10 seconds and a red LED w ill turn on.
When you enter the menu, the device w ill display a list of the sensors represented by their units
as w ell as the icon  next to each sensor w ith an enabled alarm (fig. 22).
For enabling/disabling or setting an alarm, use the arrow keys ▲ and ▼ to select the sensor you
w ish to set. Then press OK to open the specific alarm menu for the selected sensor (fig. 23).
© PCE Instruments
37