PCE Instruments PCE-AQD 50 User Manual page 35

5.4.2.1 Sensors configuration menu
This submenu allow s you to set the sampling time for each sensor and also to disable each one
of them. The sensors are represented by their units and the display will be updated depending on
the units set for the measurements.
If a sampling time is set for any of the sensors, that sensor will be enabled. The available sampling
times are: 30 seconds, 1 m inute, 2 m inutes, 10 m inutes, 15 minutes, 30 m inutes, 1 hour, 2
hours, 6 hours, 12 hours and 24 hours.
For changing the sampling time for one sensor, select the desired sensor with the arrow keys ▲
and ▼ and press the OK key; then the device w ill highlight the sampling time you are changing
in w hite (fig. 10). After that, use the arrow keys ▲ (increase sampling time) and ▼ (decrease
sampling time) to change betw een the different values for the sampling time. Once you have
reached the 24 h sampling time and press the arrow key ▲ again or have selected a sampling
time of 30 s and press the arrow key ▼, the device will display Off and the sensor will be disabled.
In the images 9 and 10, the humidity sensor is shown as disabled.
Note:
At first start-up, the sampling times are 2 minutes for all sensors but CO the default sampling
2
time of w hich is 10 minutes.
Fig. 44 Sensors selection submenu
Fig. 45 Sensors selection menu - changing temperature sampling time
Note:
When selecting 30 s as sampling rate, it is recommended to use the charging adaptor.
© PCE Instruments
32