Multi-Fiber Calibration - Parameter Method; Add, Edit, Delete Measure Task - µ-Dimension MTPro Operation Manual

MTPro operation manual
Finish the calibration following the instruction of software
Awareness in calibration
1. Keep clean endface and low vibration
2. The result window will show after calibration
4.4.3 Multi-Fiber Calibration – Parameter Method
Figure 4-17 Setting window
1. Choose parameter method in setting interface
2. Enter the x, y angle of the calibration tool and save
3. Click next to finish the calibration.

4.4.4 Add, Edit, Delete measure task

Click Edit button next to measure task, enter the password and following the steps to change
Figure 4-16 Two step method
26
Figure 4-18 Parameter Method