MTPro operation manual
5.1 Connect to PC
1. Pick out PC and MTPro
2. Connect PC and MTPro with USB3.0 and connect MTPro with 24V power supply
3. Open the software to enter the interface.
Remarks
1. Please be careful when moving MTPro
2. Confirm the datalink between MTPro and PC
3. Please refer Chapter VI when any problem occurs.
5.2 PC, APC Switch
PC to APC
1. Unlock the platform by move handle counterclockwise rotation
2. Push above the fixture to switch APC, as figure 5-1.
3. Lock the platform by move handle clockwise rotation.
Remarks:
1. When change to APC, please make sure the PC mode is calibrated.
Chapter V MTPro Installation
Push above the fixture to
switch APC.
图 5-1 PC,APC Switch
28