MTPro operation manual
2.5mm calibration tool——for calibrating 2.5mm fixture in PC mode.
1.25mm calibration tool——for calibration 1.25mm fixture in PC mode.
Remarks:
1. There is serial number at the bottom of the tool with the report.
2. Please put on dust cover and place the tool in the box to prevent scratches or loss.
3.6 SC/APC reference tool
SC/APC reference tool: for SC/APC angle reference.
Remarks:
1. The calibration with serial number has the data report.
2. Please put on dust cover and place the tool in the box to prevent scratches or loss.
3.7Fixture Lock Screw
Fixture Lock Screw: for install the fixture to the platform.
Remarks: There are two screws in the machine, please screw both screws when installing
the fixture.
Figure 3-8 SC/APC reference tool
Figure 3-9Fixture Lock Screw
14