Advertisement
A1.
For TRU-TRAC brand "2000 Series" Traction Tables:
With Clamping
Bracket (©
extended, SLIDE
the machine
fully on to the CENTER
of the
mounting
platform.
RETRACT
the Clamping
Bracket (9) by turning Clamping
Knob
clockwise
until it is firmly tightened. VERIFY
that the
Clamping Bracket @)
has securely engaged both
the platform and the structural metal support
which
is attached to the platform.
A2.
For TRU-TRAC brand "TS-93 Series" Traction Stands:
With Clamping
Bracket
extended, SLIDE the machine
down over the "T" shaped top of the stand and CENTER
in
place. RETRACT the Clamping Bracket (©
by turning
Clamping
Knob (1) clockwise until it is firmly tightened.
VERIFY that
the Clamping
Bracket @)
has securely engaged
the top
of the stand and that the stand
is securely
assembled
in accordance with its accompanying
instructions.
NOTE:
The TS-93 Series Traction Stand
is for Cervical
Traction Only — NOT TO EXCEED 50 LBS.
(22.7 kgs.)
A3.
For TRU-TRAC brand "MT-9100" Mobile Traction Stand:
Carefully mount TRU-TRAC™ traction machine to MT-9100 traction
stand plate in accordance with MT-9100
instructions. ALIGN
mounting plate studs with holes in upright staff and push
completely through
upright staff. Slide steel washers over studs
and fasten tightly with self locking nuts. VERIFY
that the MT-9100
and TT-92B
has been securely assembled
in accordance with the
MT-9100
instructions.
A4.
For TRU-TRAC brand "WM-0291" Optional Wall Mount:
With Clamping Bracket (9)
extended about one-third inch
(1 cm), SLIDE the machine down so that the Clamping
Bracket @)
fully enters the upper
opening
between
the
Wall Mount and the wall.
RETRACT the Clamping Bracket (©
by turning
Clamping
Knob (1)
clockwise until itis firmly
tightened. VERIFY that the Clamping Bracket (9) has securely
engaged the Wall Mount
and that the Wall Mount
is securely
attached to the wall in accordance
with its accompanying
instructions.
A5.
For TRU-TRAC brand "RT-99" Traction Table
(discontinued
in 1978): With the Clamping
Bracket (9) extended
SLIDE the machine
fully on to the CENTER
of the adjustable
mounting board.
RETRACT the Clamping Bracket (©
by turning
Clamping Knob (4) clockwise until it is firmly tightened.
VERIFY that the Clamping
Bracket (9)
has securely engaged
the
adjustable mounting
board and that the table is properly
assembled
in accordance
with its accompanying
instructions.
B.
This machine
is intended to be used only with tables,
stands and accessories
manufactured
by
TRU-TRAC
Therapy Products Inc. (or TRU-EZE Mfg. Co. Inc.) and specifically designed for use with a
TRU-TRAC™.
Use in any other manner is dangerous and damage may result.
Read and follow warning
on page
1.
Page 6
No. 990002C (10/85)
Advertisement
