Operating Your New Appliance - Sage SES810 Quick Manual

GETTING TO KNOW YOUR NEW APPLIANCE
CUSTOM DESIGNED
ACCESSORIES
• Razor™ Precision Dose Trimming Tool
• Single wall filter baskets for freshly
ground coffee
• Advanced dual wall filter baskets for
pre-ground coffee
• Water filter
• Stainless steel milk jug

OPERATING YOUR NEW APPLIANCE

BEFORE FIRST USE
Conditioning the Water Filter
• Remove filter from the plastic bag and soak
in a cup of water for 5 minutes.
• Rinse filter under cold running water.
• Insert the filter into the filter holder.
• Set the dial date 3 months ahead.
• To install filter, push down to lock into place.
• Slide the water tank into position and lock
into place.
NOTE
Do not clean any of the parts or
accessories in the dishwasher.
6
CLEANING ACCESSORIES
• Cleaning tool
• Silicon cleaning disk
• Cleaning tablets
• Descaling powder
FIRST USE
Initial Start Up
• Fill tank with water.
• Press POWER button.
• The machine will reach operating temperature
and go into 'Standby' mode.
Flushing the Machine
It is recommended to complete a water flushing
operation, without ground coffee, to ensure the
machine has been conditioned.
When the machine has reached 'Standby' mode,
run the following 2 steps.
• Turn the Control Dial to the 'Espresso'
position for 30 seconds.
• Turn the Control Dial to the 'Steam' position
to activate steam for 10 seconds.
• Repeat this cycle several times.
FILLING THE WATER TANK
• Fill the water tank with cold tap water to the
maximum mark on the side of the tank and
slide the water tank back into position at the
back of the machine.
• Plug the power cord into power outlet and
switch On at power point.
• Press the POWER button. The POWER
button surround will flash while the machine
is heating. When the correct temperature
has been reached, all the button surrounds
on the control panel will illuminate.