Table of Contents
Advertisement
Problem solving guide
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Indicator lights or information in the time display
Problem
The indicator light
lights up at the end of
the programme.
The indicator light
comes on. and
light up after a
programme has been
cancelled, a signal tone
sounds.
50
Possible cause and remedy
The tumble dryer is not working correctly or
economically. Possible causes could be clogging
caused by fluff or detergent residues.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Please see "Cleaning and care" for notes on
cleaning.
Clean the fluff filters.
Also check the plinth filter and clean it if
necessary.
You can influence when the indicator light comes
on.
Follow the instructions in "Programmable functions
- Airways indicator".
The system is clogged by fluff or detergent residues.
To deactivate the message, turn the programme
selector to the position.
Clean the fluff filters and the plinth filter.
Please see "Cleaning and care" for notes on
cleaning.
Check that the fluff filters and the plinth filter are
not damaged or worn.
If all fluff filters are damaged, deformed or cannot be
cleaned anymore, they must be replaced. For
information on when to replace a plinth filter that is
not functioning properly, refer to "Problem solving
guide - Replacing the plinth filter".
Advertisement
Table of Contents
