Preparing the remote control
Power supply
Insert the battery
(Lithium battery)
■ Replacing the button-type battery
The battery normally lasts for about a year.
Replace if the remote control fails to oper¬
ate the unit when used within the operation
range.
Note
Refer to "PRECAUTIONS" on pages 6 and 7.
Operation range
Remote control
signal sensor
About 7 m
(23 feet) in
front of the
signal sensor
10
•Do not expose the remote control signal
sensor to bright light.
•Do not place obstacles between the re¬
mote control signal sensor and the re¬
mote control.
•Do not use another unit's remote control
at the same time.
Using the AC adaptor
Front of this unit
Note
Refer to "PRECAUTIONS" on page 6.
The unit is in the standby condition (the
[(])] indicator lights) when the AC power
supply cord is connected. The primary
circuit is always "live" as long as the AC
adaptor is connected to an electrical
outlet.
■ When the unit is not going to be used
for a long time
The unit consumes 2 W when in standby
mode.
To conserve power, disconnect the AC
power supply cord from the AC outlet.
RGT5603