Table of Contents
Advertisement
Enjoying surround sound
Amplifier with a built-in decoder or a
decoder-amplifier combination
•
You cannot use DTS Digital Surround
decoders not suited to DVD.
Set "AUDIO OUT" to "OFF"
( page 20, "HDMI" menu), and change
"PCM OUTPUT", "DOLBY DIGITAL" and
"DTS" ( page 20, "AUDIO" menu).
STEP 2 The remote control
Batteries
R6/LR6, AA
STEP 3 QUICK SETUP
Turn on the television and select the appropriate video input on the television.
1
Power on
To change these settings later, select "QUICK SETUP" ( page 20, "OTHERS" menu).
COAXIAL IN
Coaxial cable
Back of the unit
•
Insert so the poles (4 and 3) match those in the remote
control.
•
Do not use rechargeable type batteries.
Do not:
•
mix old and new batteries.
•
use different types at the same time.
•
heat or expose to flame.
•
take apart or short circuit.
•
attempt to recharge alkaline or manganese batteries.
•
use batteries if the covering has been peeled off.
2
3
Shows QUICK
Follow the message and
SETUP screen.
make the settings.
Connect the AC power supply cord last
AC power supply cord (included)
To household AC outlet
Conserving power
This unit consumes a small amount of power, even when it is turned off (1 W). To save
power when the unit is not to be used for a long time, unplug it from the household AC
outlet.
For areas except the U.S.A. and Canada
If the power plug does not fit your AC outlet, use the
power plug adaptor (included). If it still doesn't fit,
contact an electrical parts distributor for assistance.
Mishandling of batteries can cause electrolyte leakage which
can damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
Use
Aim at the remote control sensor ( page 10), avoiding
obstacles, at a maximum range of 7 m (23 feet) directly in front
of the unit.
4
Select
Register
Press to finish
QUICK SETUP.
AC IN
5
Press to exit.
9
Advertisement
Table of Contents
