Fault Messages; Statutory Regulations Governing Installation; Declaration Of Conformity - Webasto ThermoConnect TCon2 Operating And Installation Instructions

done with the pushbutton: Press and hold
EN
the pushbutton for 10 seconds to approve
a new user.
14

Fault messages

The following heater faults are displayed as
fault messages in the ThermoConnect app.
You will find further information in the
operating instructions for the heater.
WARNING
Inspections and repairs on heaters
must only be carried out by trained
personnel.
Fault mes- Fault Description
sages code
Heater 0x06 Overheating lock-out
overheating has tripped (heater
overheated).
Heater lock- 0x07 Heater lock-out was
out activated.
Permanent 0x87 Permanent heater
heater lock- lock-out was activ-
out ated.
Operating 0x84 Supply voltage is too
voltage too low. Charge the bat-
low tery and check car
electrical installation.
10
Fault mes- Fault Description
sages code
Supply 0x04 The operating voltage
voltage too was higher than the
high maximum permissible
value for too long.
15 Statutory regulations
governing installation
Regulation Typ approval number
ECE R10 E17 10 R - 050151
The provisions of these regulations are
binding within the scope of EU Regulation
2018/858 and should also be observed in
countries where there are no special regu-
lations! Failure to follow the installation in-
structions and the notes contained therein
will lead to all liability being refused by
Webasto.
WEEE directive This product
must not be disposed of with
normal household waste.
Dispose of this product according to the
applicable rules and regulations. Informa-
tion about proper disposal is provided by
the municipal authorities, the responsible
household waste recycling centre and/or
your local distribution partner.
The provisions of these regulations are
binding within the scope of EU Regulation
2018/858 and should also be observed in
countries where there are no special regu-
lations! Failure to follow the installation in-
structions and the notes contained therein
will lead to all liability being refused by
Webasto.
16

Declaration of Conformity

CE-Declaration of Conformity and UKCA-
Declaration of Conformity
The ThermoConnect TCon2 was de-
veloped, manufactured, tested and sup-
plied in accordance with the relevant dir-
ectives, regulations and standards for
safety, EMC and environmental compatibil-
ity. Webasto declares that the product
ThermoConnect TCon2 is manufactured
and delivered in accordance with the dir-
ectives and regulations.
The complete CE Declaration of Conformity
and UKCA Declaration of Conformity can
be found in the download area at
https://dealers.webasto.com.
9040092D